Replacing A Front Turn Signal Light Bulb - Yamaha XMAX YP250R Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
1. Headlight bulb holder
TIP
The removal procedure depends on
the type of bulb holder installed on
6
your vehicle.
4. Place a new bulb into position,
and then secure it with the bulb
holder.
5. Install the bulb cover, and then
connect the coupler.
6. Install the cowling.
7. Have a Yamaha dealer adjust the
headlight beam if necessary.
Replacing a front turn signal
light bulb
NOTICE
It is advisable to have a Yamaha
dealer perform this job.
1. Place the scooter on the centers-
tand.
2. Remove cowling A. (See page
6-6).
3. Remove the socket (together
with the bulb) by turning it coun-
terclockwise.
1. Turn signal light bulb socket
4. Remove the burnt out bulb by
pushing it in and turning it coun-
terclockwise.
6-28
EAUT1261 5. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
ECA10670
6. Install the socket (together with
the bulb) by turning it clockwise.
7. Install the cowling.