Rear Turn Signal Light And Tail/Brake Light; Replacing The Auxiliary Light Bulb - Yamaha VITY XC125E Owner's Manual

5. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
6. Install the socket (together with the
bulb) by turning it clockwise.
7. Install the cowling.
PERIODIC MAINTENANCE AND ADJUSTMENT
Rear turn signal light and
tail/brake light
If a rear turn signal light or the tail/brake
light does not come on, have a Yamaha
dealer check its electrical circuit or re-
place the bulb.
6-27
EAU37741
Replacing the auxiliary light
bulb
If the auxiliary light bulb burns out, re-
place it as follows.
1. Place the vehicle on the center-
stand.
2. Remove cowling A. (See page
6-6.)
3. Remove the auxiliary light socket
(together with the bulb) by pulling it
out.
1. Auxiliary light bulb
2. Auxiliary light bulb socket
4. Remove the burnt-out bulb by pull-
ing it out.
5. Insert a new bulb into the socket.
EAU45462
6
1 2