Table of Contents
Advertisement
PLUG THE POWER CORD
7
INTO A GROUNDED OUTLET
Insure proper ground
exists before use
INSTALLATION CHECKLIST
8
Before starting the washer, check to make sure:
❏ Main power is turned on.
❏ The washer is plugged in.
❏ The water faucets are turned on.
❏ The unit is level.
❏ The drain hose is properly tied up.
❏ There are no leaks at the faucet, drain line
or washer.
RUN THE WASHER THROUGH
9
A COMPLETE CYCLE
Check for water leaks and proper operation.
ALCOVE OR CLOSET INSTALLATION
If your washer is approved for installation in an
alcove or closet, there will be a label on the back
of the machine describing requirements.
• Minimum clearances between washer and adjacent
walls or other surfaces are: 0" (0 cm) either side,
1" (2.5 cm) front, 4" (10.2 cm) rear.
• Minimum vertical space from top of washer to
overhead shelves, cabinets, ceilings, etc. is 17"
(43.2 cm).
• Closet doors must be louvered or otherwise
ventilated and have at least 72 square inches open
area for washer only, or if the closet contains both
a washer and dryer, doors must contain at least
144 square inches of open area equally distributed.
NOTE: The clearances stated on this label are
minimums. Consideration must be given to
providing adequate clearances for installation
and servicing.
Installation Instructions
17" (43.2 cm)
REMOVE THE PROTECTIVE FILM
10
COVERING THE CONTROL PANEL
READ THE REST OF THIS
11
OWNER'S MANUAL
It contains valuable and helpful information that will
save you time and money.
NOTE: If your washer does not operate, please review
the Before You Call For Service section.
Front view
Side view
"
0"
22
1
⁄
0"
24"
2
(0 cm)
(57.2 cm)
(0 cm)
(61 cm)
1"
(2.5 cm)
Closet door with vents
14" max.
(7.6 cm)
(35.6 cm)
48 in.
2
(310 cm
2
)
24 in.
2
(155 cm
2
)
(7.6 cm)
4"
(10.2 cm)
3"
3"
13
Advertisement
Table of Contents
