GE WSKS3040 Owner's Manual & Installation Instructions

Ge washers owner's manual & installation instructions wsks3040

Advertisement

Quick Links

ge.com
Safety Information
Owner's Manual &
Installation Instructions
Operating Instructions
WSKS3040
Installation Instructions
Troubleshooting Tips
Consumer Support
Write the model and serial
numbers here:
#
#
175D1807P526
49-90258 11-05 JR

Advertisement

Table of Contents
loading

Summary of Contents for GE WSKS3040

  • Page 1 Safety Information Owner’s Manual & Installation Instructions Operating Instructions WSKS3040 Installation Instructions Troubleshooting Tips Consumer Support Write the model and serial numbers here: 175D1807P526 49-90258 11-05 JR...
  • Page 2: Important Safety Information

    Since the gas is flammable, do not smoke or use an open flame or appliance during this process. PROPER INSTALLATION This washer must be properly installed and located in accordance with the Installation Instructions before it is used. Install or store where it will not be exposed to temperatures below freezing or exposed to the weather.
  • Page 3 5 years. Before discarding a washer, or removing it from service, remove the washer lid to prevent children from hiding inside. READ AND FOLLOW THIS SAFETY INFORMATION CAREFULLY. SAVE THESE INSTRUCTIONS...
  • Page 4: About The Washer Control Panel

    DELICATES Use this cycle to get 6 minutes of wash time for lingerie and loosely knit items. LOAD SIZE Loosely load clothes no higher than the top row of holes in the washer basket. The water level should just cover the clothes. Adjust the load size accordingly. Press the LOAD SIZE button to select the correct setting for your wash load and type of fabric being washed.
  • Page 5: About The Washer Features

    Fabric Softener Dispenser The fabric softener dispenser automatically releases liquid fabric softener at the proper time during the cycle. Do not stop the washer during the first spin. This will cause the dispenser to empty too soon. Cleaning the Fabric Softener Dispenser Flush fabric softener dispenser periodically with warm water.
  • Page 6: Loading And Using The Washer

    Water level should just cover the clothes. To add items after washer has started, open the lid and add the additional items. Close the lid. Washer will start automatically.
  • Page 7: Fabric Care Labels

    Loading and using the washer. Fabric Care Labels Below are fabric care label “symbols” that affect the clothing you will be laundering. WASH LABELS Machine wash cycle Water temperature DRY LABELS Tumble Heat setting High Special instructions BLEACH LABELS Bleach...
  • Page 8: Installation Instructions

    Installation Instructions If you have questions, call 800.GE.CARES or visit our Website at: ge.com BEFORE YOU BEGIN Read these instructions completely and carefully. IMPORTANT – • instructions for local inspector’s use. IMPORTANT – • governing codes and ordinances. Note to Installer –...
  • Page 9: Remove Shipping Material

    • To protect the floor, place two corner posts from the shipping material on the floor in back of the washer. • Firmly grasp the body of the washer and gently lay it on the corner posts. • Remove plastic foam packaging from under the washer.
  • Page 10: Washer Connections

    WARNING: Make sure the washer is unplugged. DRAIN SYSTEM The washer can be installed using the standpipe drain system (floor to wall) or the laundry tub drain system. Select the drain hose installation method you need. Standpipe drain system—wall to floor The standpipe drain requires a minimum diameter standpipe of 2″...
  • Page 11: Connect Inlet Hoses

    • Put hooked end of drain hose into laundry tub or standpipe. Rotate hook to eliminate kinks in the hose. To prevent drain water from going back into the washer: • Do not straighten hooked end of drain hose. Do not force excess drain hose into standpipe.
  • Page 12: Secure Drain Hose

    • Move washer to final location. • Check that the washer is level from side to side and • If the washer is not level, prop up the front of the cardboard used to move washer. Beaded tie strap standpipe with the tie strap, as shown below.
  • Page 13: Installation Checklist

    • Closet doors must be louvered or otherwise ventilated and have at least 72 square inches open area for washer only, or if the closet contains both a washer and dryer, doors must contain at least 144 square inches of open area equally distributed.
  • Page 14: Before You Call For Service

    • Make sure house water heater is delivering water at 120°F–140°F (48°C–60°C). • Straighten drain hose and make sure washer is not sitting on it. • Top of drain outlet should be less than 72″ (183 cm) above floor.
  • Page 15 • Make sure load size selected matches clothes load size. • Check fabric softener package for instructions and follow directions for using dispenser. • While this is not caused by the washer, you can slow the pilling process by washing garments inside out. ge.com...
  • Page 16 • Press the START/OFF button to stop the washer, open the lid and redistribute the load evenly. Close the lid and restart. • Pull washer away from the wall; about 4″ is needed. WHAT TO DO • Use a hair dryer set at the lowest heat setting, directing the air at the label for a short amount of time.
  • Page 17 You can rest easy, knowing that all your valuable household products are protected against expensive repairs. Place your confidence in GE and call us in the U.S. toll-free at for more information. *All brands covered, up to 20 years old, in the continental U.S.
  • Page 18: Model Number

    Check here if you do not want to receive communications from GEA’s carefully selected partners. FAILURE TO COMPLETE AND RETURN THIS CARD DOES NOT DIMINISH YOUR WARRANTY RIGHTS. For information about GEA’s privacy and data usage policy, go to ge.com and click on “Privacy Policy” or call 800.626.2224. Read your Owner’s Manual carefully.
  • Page 19 This warranty is extended to the original purchaser and any succeeding owner for products purchased for home use within the USA. If the product is located in an area where service by a GE Authorized Servicer is not available, you may be responsible for a trip charge or you may be required to bring the product to an Authorized GE Service location.
  • Page 20: Consumer Support

    Caution must be exercised, since improper servicing may cause unsafe operation. Contact Us If you are not satisfied with the service you receive from GE, contact us on our Website with all the details including your phone number, or write to: General Manager, Customer Relations Register Your Appliance Register your new appliance on-line—at your convenience! Timely product registration will allow for...

This manual is also suitable for:

Spacemaker wsks3040e

Table of Contents