Table of Contents
Advertisement
WASHER CONNECTIONS FOR STATIONARY MODEL
WSLS1100 (CONT.)
INSTALLATION CHECKLIST
6
Before starting the washer, check to make sure:
❏ Main power is turned on.
❏ The washer is plugged in.
❏ The water faucets are turned on.
❏ The unit is level.
❏ The drain hose is properly tied up.
❏ There are no leaks at the faucet, drain line
or washer.
7
RUN THE WASHER THROUGH A
COMPLETE CYCLE
Check for water leaks and proper operation.
ALCOVE OR CLOSET INSTALLATION
If your washer is approved for installation in an
alcove or closet, there will be a label on the back
of the machine describing requirements.
• Minimum clearances between washer and adjacent
walls or other surfaces are: 0" either side, 2" front,
3" rear.
• Minimum vertical space from floor to overhead
shelves, cabinets, ceilings, etc. is 96" .
• Closet doors must be louvered or otherwise
ventilated and have at least 60 square inches open
area for washer only, or if the closet contains both
a washer and dryer, doors must contain at least
120 square inches of open area equally distributed.
NOTE: The clearances stated on this label are
minimums. Consideration must be given to
providing adequate clearances for installation
and servicing.
12
Installation Instructions
REMOVE THE PROTECTIVE FILM
8
COVERING THE CONTROL PANEL
READ THE REST OF THIS
9
OWNER'S MANUAL
It contains valuable and helpful information that will
save you time and money.
NOTE: If your washer does not operate, please review
the Before You Call For Service section.
Closet door
60 sq. in.
(387.1 sq. cm)
60 sq. in.
(387.1 sq. cm)
Hide quick links:
Advertisement
Table of Contents
