Display Setup - Honeywell 10X User Manual

Display Setup

DISPLAY SETUP
------------------------
CAMERA ID
PTZ INFORMATION
ACTION TITLE
PRESET LABEL
ALARM I/O
<SET NORTH DIRECTION>
<PRIVACY ZONE>
BACK
EXIT
Compass Direction Setup
SET NORTH DIRECTION
------------------------
MOVE TO TARGET POSITION
[NEAR:SAVE /FAR:CANCEL
Document 800-06705 - Rev A - 12/10
Display setup allows you to program how labels are displayed on the
monitor. In case of AUTO, the labels are displayed on the monitor when
ON
there are any changes in parameters.
AUTO
AUTO
AUTO Camera ID
AUTO
PTZ Information
Action Title
Preset Label
Move the camera to a target position and press the NEAR button to save
the direction as North. The direction is the reference direction to assign
other compass directions.
Mini PTZ Dome Camera User Guide
[ON/OFF]
Displays the selected camera ID (address).
[ON/OFF/AUTO]
Displays the amount of pan from zero degrees
vertical, the amount of tilt from zero degrees
horizontal, the current compass direction, and the
amount of zoom magnification.
[ON/OFF/AUTO]
Identifies actions.
"SET PRESET xxx"
"PRESET xxx"
"PATTERN x"
"SWG/PRESET xxx"
"UNDEFINED"
[ON/OFF/AUTO]
Displays the preset labels when the camera arrives
at presets.
33