Pattern - Honeywell 10X User Manual

Operation

Pattern

Function
Setting Patterns
Running Patterns
Deleting Patterns
Note) When the system memorizes Patterns, the joystick commands are stored in the memory rather than the
specific pan/tilt/zoom positions of the camera. As a result, there may be small differences between the original path
and the path used by the Pattern. Note that it is not a problem of position precision.
28
This function causes the camera to memorize the curve path created by the controller
joystick and to duplicate that trajectory as closely as possible.
Maximum four Patterns are programmable and maximum 1,200 communication
commands can be programmed in a pattern.
A Pattern can be created by the following methods:
Method 1) <Set Pattern> [Pattern no.]
The Pattern programming window appears on the monitor as below.
The joystick movement and the Preset movement can be memorized in a pattern.
After a Pattern is programmed, the amount of storage remaining is displayed in a
progress bar on the screen.
To save the recording, press the NEAR key and to cancel, press the FAR key.
Method 2) Program using the OSD menu. See the section "OSD Menu".
Method 1) <Run Pattern> [Pattern no.]
Method 2) <Go Preset> [Pattern no. + 130]
To delete a Pattern, enter the OSD menu.
EDIT PATTERN 1
[NEAR:SAVE /FAR:DELETE]
0/0/x1/N
For example, Run Pattern 2: <Run
Pattern> [2]
For example, Run Pattern 2: <Go Preset>
[132]