Setting The Clock; Remote Control - Sharp CD-M4000W Service Manual

Setting the Clock

In this example, the clock is set for the 24.hour CO:001 disolav.
Press the ON/STAND-BY button to turn the power on.
hour display and then press the MEMORY/SET button.
" AM 12:OO"
(AM 12' 00 -PM ,159)
" AM OXlO"
(AM O:OO. PM 11:59)
Note that this can only be set when the unit IS first installed or it has been reset.

Remote Control

Face the remote control directly to the rem& sensor on the wt.
The remote control can be used within the range shown below:
Press the ON/STAND-BY button Does the power turn on? Now. you can enjoy the
music.
press the MEMORY/SET button.
. Press the TUNlNG,TlME (v or A) button once to advance the time by 1 hour.
Hold it down to advance contnuousiy.
Press the TUNING/TIME (v or A) button to adjust the minutes and
then press the MEMORYISET
. Press the TUNlNG,TlME (v or A) button once to advance the time by 1
minute. Hold it down to change the bme in 5mmute Intervats.
The clock begins counting from " 0" seconds. (Seconds are not displayed.)
l
The time dlsptay will disappear after a few seconds.
To confirm the time display:
Press the CLOCK button.
The time display will appear for about 5 seconds.
Note:
The " CLOCK" or iime will flash at the push of the CLOCK button when the AC power
supply is restored after a power failure or unplugging the " nit.
Readjust the clock as follows.
To readjust the clock:
Perform " Setting the Clock" from the begrnning. If the time display IS flashing, step 3
(for selecting the 24.hour or 12.hour display) will be skipped.
To change the 24-hour or Is-hour display:
1 Clear ali the programmed contents.
2 Perform " Setting the Clock" from the beginning.
Remote sensor
button.
I