Location Of Your Washer; Rough-In Dimensions - GE LAVEUSES GBVH5140 Owner's Manual & Installation Instructions

Installation Instructions
LOCATION OF YOUR WASHER
Do Not Install the Washer:
1. In an area exposed to dripping water or outside
weather conditions, The ambient temperature
should never be below 60°F (] 5.6°C) fl)r proper
washer operation,
2. In an area where it will come in contact with curtains
or drapes.
3. On caq_et. Tile floor MUST be a hard sm'iace with
a maximum slope of 1/2" per fi)ot (1.27 cm per
30 cm). To make sm'e tile washer does not vibrate
or IllOVe, yo/i Ill,Iv have to reinfl)rce tile floor.
NOTE: If floor is in poor condition, use 3/4"
impregnated plywood sheet solidly attached to existing
floor covering.
IMPORTANT:
Minimum Installation Clearances
* _._]/en installed in alcove: Sides, Rein;
Top
: 0"
(0 cm)
* _A]/en installed in closet: Sides, Rein;
T(,p 0"
(0 cm), Front l" (2,54 cm)
* Closet door ventilation openings required:
2 louve_ each 60 square in, (387 cm_), located 3"
(7.6 cm) ti'om top and bottom of door
ROUGH-IN DIMENSIONS
FRONT
27.0"
(68.6cm)
20.4" (51.9cm)
ELECTRONIC TRANSPARENT VISOR
40.6"_
(103.1cm)
SIDE
30.6"
177.7 cm)
1.6"
(3.9 cm)
_NOTE: W ith pedestal,52.6"
Stacked,84"
40.6 "_
(lO&lcm)
39.1"
(09.2cm)
15