Installation Instructions; Location Of Your Washer; Rough-In Dimensions - GE GFWR4805 Owner's Manual & Installation Instructions

Installation Instructions
LOCATION OF YOUR WASHER
Do Not Install the Washer:
1. In an area exposed to dripping water or outside
weather conditions. The ambient temperature
should never be below 60°F (15.6°C)for proper
washer operation.
2. In an area where it will come in contact with curtains or
drapes.
3.On carpet. The floor MUST be a hard surface with
a maximum slope of 1/2" per foot (1.27 cm per
30 cm). To make sure the washer does not vibrate
or move, you may have to reinforce the floor.
NOTE: If floor is in poor condition, use 3/4" impregnated
plywood sheet solidly attached to existing floor covering.
IMPORTANT:
Minimum Installation Clearances
. When installed in alcove: Sides, Rear,
Top = 0" (0 cm)
. When installed in closet: Sides, Rear,
Top = 0" (0 cm), Front = 1" (2.54 cm)
. Closet door ventilation openings required:
2 louvers each 60 square in. (387 cm), located 3"
(7.6 cm) from top and bottom of door
ROUGH-IN DIMENSIONS
FRONT
28"
(7!.!2cm)
39"* 46"*
(99cm) (ll7cm)
SIDE
54 3/8"
(!38.2cm)
39"* 46"*
(99cm) (117cm)
Built-In
Pedestal
T M
models
only
l::t
35"
(88.9cm)
*NOTE:
With Legs: 40 1/2" (102.S cm) - 13/4" 11.9cm) edjustebility)
With Built-In PedestaF": 46" 1117 cm) - 13/4" 11.9cm) edjustebility)
With Optional Pedestal IGF×P1308}: 52" 1132.1cm) - 13/4" 11.9cm) odjustebility)
Stacked: 78 1/4" 1198.8cm)
19