Epson EPL-N2050+ Setup Manual page 36

3. Carefully lift the Multibin Unit, holding it so that the drawers
are facing the same direction as the front of the printer. Lift
the unit over the printer, tilt the front end slightly downward,
and fit the metal hook into the hook slot.
4. Note the location of the interface plug on the Multibin Unit
and its counterpart on the printer. Lower the rear of the unit
into place and make sure the plug is inserted properly into
the receptacle on the printer. Slide the unit slightly as
necessary so that the plastic tabs snap into the slot along the
rear of the printer.
30
Installing the Options