Installing A Memory Module; Attaching The Cover; Removing And Installing The Hard Disk; Removing A Hard Disk - Fujitsu M2010 Operating Manual

Removing and installing components during servicing

Installing a memory module

1

Attaching the cover

► Place the cover in the correct mounting position (1).
If you remove more than one component at the same time, keep the screws for the
individual components separate from each other and make sure that you use the correct
screws. If you install the wrong screws, components may be damaged.
► Fasten the "Torx 6" M2 x 4 mm screws (2).

Removing and installing the hard disk

Removing a hard disk

The service compartment for the hard disk is located behind the battery and is
only accessible once the battery is removed.
► Remove the battery (see
40
2
a
"Removing a battery", Page
► Insert the memory module with the contacts
and the recess (a) facing the slot (1).
Memory module Memory expansion
► Carefully push the memory module
downwards until you feel it click
into place (2).
2
1
23).
A26391-K245-Z220-1-7619, edition 1