Selecting A Location; Mains Adapter Connecting - Fujitsu M2010 Operating Manual

Selecting a location

Selectinga location Mainsadapter Device
Select a suitable location for the device before setting it up. Follow
the instructions below when doing so:
• Never place the device or the mains adapter on a heat-sensitive surface.
The surface could be damaged as a result.
• Never place the device on a soft surface (e.g. carpeting, upholstered furniture,
bed). This can block the air vents and cause overheating and damage.
• The underside of the device heats up during normal operation. Prolonged contact
with the skin may become unpleasant or even result in burns.
• Place the device on a stable, flat, non-slippery surface. Please note that the
rubber feet of the device may mark certain types of delicate surfaces.
• Keep other objects at least 100 mm away from the device and its
mains adapter to ensure adequate ventilation.
• Never cover the ventilation slots of the device.
• Do not expose the device to extreme environmental conditions. Protect
the device from dust, humidity, and heat.

Mains adapter connecting

Mainsadapter Preparingforoperation
Observe the safety precautions in the enclosed "Safety" manual.
The supplied power cable conforms to the requirements of the country in
which you purchased your device. Make sure that the power cable is approved
for use in the country in which you intend to use it.
The mains adapter's power cable should only be connected to a mains socket
if the device is connected to the mains adapter.
Make sure that the rated current of the mains adapter is not higher than
that of the mains supply to which you connect the mains adapter (see
chapter "Technical Data"
1
2
A26391-K245-Z220-1-7619, edition 1
"Mains adapter", Page
► Connect the mains adapter cable (1) to
the DC jack (DC IN) of the device.
► Connect the power cable (2) to the
mains adapter.
► Plug the power cable (3) into a mains outlet.
3
First-time setup of your device
51).
9