Using The Downdraft System; Using The Cooktop - GE JVB37 Owner's Manual & Installation Instructions

Using the downdraft system.

On some models, the Raise/Lower
switch is located at the top right of
the vent.
Use the selector switch to turn the
blower ON, OFF or to change the
blower speed.
Raise/Lower switch location
may vary.
4
Raise/Lower Switch
(30" models only)
Turn the downdraft blower ON by pressing
the raise/lower switch located at the top
right of the vent. Place your finger on the
"center" of the switch and hold until you
observe the vent moving, then release.
The air vent will rise. Use the selector switch
to turn the blower ON, OFF or to change
the blower speed.
The vent may be lowered by again pressing
the raise/lower switch at the top right side
of the vent. The blower, if left on, will
automatically go off when the vent is
lowered.
Remote Raise/Lower Switch
The 36" models have a remote raise/lower
switch. It operates in the same manner as
the switch located on the vent. This switch
may be located beside the cooktop or in a
convenient location.

Using the Cooktop

CAUTION:
Be careful when raising
or lowering the downdraft. Be sure pots, pot handles
and other objects are clear of the downdraft
and cannot be struck or tipped by the downdraft
being raised.
NOTE: There is a slight trim overhang at each end
of the vent.
NOTE: For most convenient operation, set the
blower to the speed you use most often. The
blower will come on to this speed whenever
the unit is raised.
(36" models only)
I
To avoid injury, be sure fingers are clear
of the downdraft cover when it is being
lowered.
I
Keep hands and fingers away from all
downdraft parts.