Cisco Catalyst 2960 Getting Started Manual page 9

Chapter 1 Getting Started Guide
Step 11 Enter this information in the Network Settings fields:
• In the Management Interface (VLAN ID) field, the default is 1. Enter a new VLAN ID
only if you want to change the management interface through which you manage the switch
and to which you assign IP information. The VLAN ID range is 1 to 1001.
In the IP Address field, enter the IP address of the switch. In the IP Subnet Mask field,
•
click the drop-down arrow, and select an IP Subnet Mask.
In the Default Gateway field, enter the IP address for the default gateway (router).
•
Enter your password in the Switch Password field. The password can be from 1 to 25
•
alphanumeric characters, can start with a number, is case sensitive, allows embedded
spaces, but does not allow spaces at the beginning or end. In the Confirm Switch
Password field, enter your password again.
Step 12 (Optional) You can enter the Optional Settings information now or enter it later by using the
device manager interface:
In the Host Name field, enter a name for the switch. The host name is limited to 31
•
characters; embedded spaces are not allowed.
In the System Contact field, enter the name of the person responsible for the switch. In the
•
System Location field, enter the wiring closet, floor, or building where the switch is
located.
In the Telnet Access field, click Enable if you are going to use Telnet to manage the switch
•
by using the command-line interface (CLI). If you enable Telnet access, you must enter a
Telnet password.
In the Telnet Password field, enter a password. The Telnet password can be from 1 to 25
•
alphanumeric characters, is case sensitive, allows embedded spaces, but does not allow
spaces at the beginning or end. In the Confirm Telnet Password field, enter the Telnet
password again.
In the SNMP field, click Enable to enable Simple Network Management Protocol
•
(SNMP). Enable SNMP only if you plan to manage switches by using CiscoWorks2000 or
another SNMP-based network-management system.
If you enable SNMP, you must enter a community string in the SNMP Read Community
field, the SNMP Write Community field, or both. SNMP community strings authenticate
access to MIB objects. Embedded spaces are not allowed in SNMP community strings.
When you set the SNMP read community, you can access SNMP information, but cannot
modify it. When you set the SNMP write community, you can access and modify SNMP
information.
OL-9368-03
Catalyst 2960 Switch Getting Started Guide
Running Express Setup
1-7