Installation Warning Statements - Cisco Catalyst 2960 Getting Started Manual

Rack-Mounting

Installation Warning Statements

Warning
Warning
Warning
Warning
Warning
Catalyst 2960 Switch Getting Started Guide
1-12
This section includes the basic installation warning statements. Translations of
these warning statements appear in the Regulatory Compliance and Safety
Information for the Catalyst 2960 Switch guide.
Only trained and qualified personnel should be allowed to install, replace, or
service this equipment. Statement 148
To prevent the switch from overheating, do not operate it in an area that
exceeds the maximum recommended ambient temperature of 113°F (45°C). To
prevent airflow restriction, allow at least 3 inches (7.6 cm) of clearance around
the ventilation openings. Statement 17B
Installation of the equipment must comply with local and national electrical
codes. Statement 1074
To prevent bodily injury when mounting or servicing this unit in a rack, you must
take special precautions to ensure that the system remains stable. The
following guidelines are provided to ensure your safety:
This unit should be mounted at the bottom of the rack if it is the only unit in the
rack.
When mounting this unit in a partially filled rack, load the rack from the bottom
to the top with the heaviest component at the bottom of the rack.
If the rack is provided with stabilizing devices, install the stabilizers before
mounting or servicing the unit in the rack. Statement 1006
This equipment is intended to be grounded. Ensure that the host is connected to
earth ground during normal use. Statement 39
Chapter 1 Getting Started Guide
OL-9368-03