Integrated Peripherals - Foxconn G43MX Series User Manual

Integrated Peripherals

CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc.
► OnChip ATA Devices
► OnBoard Devices
► SuperIO Configuration
► USB Configuration
↑↓←→:Move Enter:Select
► OnChip ATA Devices/OnBoard Devices/SuperIO Configuration/USB Configuration
Press <Enter> to go to relative submenu.
onChip ATA Devices
SATA#1 Configuration
Configure SATA#1 as
SATA#2 Configuration
↑↓←→:Move Enter:Select
► SATA#1 Configuration
SATA#1 are the SATA ports 1, 2, 3, 4 of the motherboard. This item allows you select the
mode of the SATA ports. Setting values are: [Disabled], [Compatible], [Enhanced].
► Configure SATA#1 as
This item is used to set the operation mode of your SATA ports 1, 2, 3, 4. Setting values are:
[IDE]; [AHCI].
[IDE] - This configures the SATA ports to support IDE mode.
[AHCI] - The Advanced Host Controller Interface (AHCI) specification describes the register
Integrated Peripherals
+/-/:Value F10:Save ESC:Exit
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
OnChip ATA Devices
+/-/:Value F10:Save ESC:Exit
[Press Enter] [Press Enter]
[Press Enter]
[Press Enter] OnChip ATA Devices
[Press Enter]
F9:Optimized Defaults
[Enhanced]
[IDE]
[Enhanced]
Disabled
Compatible
Enhanced
F9:Optimized Defaults
33
Help Item
F1:General Help
Help Item
Options
F1:General Help