Fox Intelligent Stepping - Foxconn A7DA-S User Manual

Fox Intelligent Stepping

CPU Clock
Memory Speed Mode
GFX Engine Clock Override
PCI Express Clock
CPU Multiplier Adjust
Spread Spectrum
CPU-NB HT Link Speed
NCHT Incoming Link Width
NCHT Outgoing Link Width
Advanced Clock Calibration
↑↓←→:Move Enter:Select
► CPU Clock
This option is used to adjust the CPU clock.
► Memory Speed Mode
This item is used to enable/disable provision of DRAM timing by SPD device. The Serial
Presence Detect (SPD) device is a small EEPROM chip, mounted on a DDR2 memory
module. It contains important information about the module's speed, size, addressing mode
and various other parameters, so that the motherboard memory controller (chipset) can better
access the memory device.
Select [Auto] for SPD enable mode.
Select [Limit], the DRAM speed will not exceed the specified value listed in the "Memory
Speed Adjust" item. If SPD value is faster than "Memory Speed Adjust" value, it will run at the
specified "Memory Speed Adjust" speed. Otherwise, SPD value is selected.
Select [Manual], then DRAM speed is manually selected according to the set value of
"Memory Speed Adjust".
► Memory Speed Adjust
This item will appear only when the "Memory Speed Mode" is set to [Limit] or [Manual].
The available settings are : [400MHz], [533MHz], [667MHz], [800MHz], [1066MHz].
[1066MHz] will appear only in AM2+ CPU.
► GFX Engine Clock Override
This item allows you to enable/disable GFX Engine Clock Override support.
► GFX Engine Clock
This item will appear only when "GFX Engine Clock Override" is set to [Enabled], it allows you
to change the clock rate of graphics engine. You can use the <+> or <-> keys to change the
value, or you can type the desired value by using the numeric keypad.
► PCI Express Clock
This option is used to adjust the speed of PCI Express slot. It may enhance the graphics card
speed.
CMOS Setup Utility - Copyright (C) 1985-2006, American Megatrends, Inc.
Fox Intelligent Stepping
+/-/:Value
[200] 200
[Auto]
[Disabled]
[100]
[Auto]
[Enabled]
[Auto]
[Auto]
[Auto]
[Disabled]
F10:Save ESC:Exit
F9:Optimized Defaults
29
Help Item
F1:General Help