Foxconn A7DA-S User Manual page 107

2. Select a RAID array for use (also can refer to section 5-3)
After rebooting your computer, you will see the RAID software prompting you to
press [Ctrl-F].
Press [Ctrl-F] to enter the FastBuild BIOS setup and configure the mirrored RAID
array as described in the 5-3 section. Finally, you can reach this step as depicted.
FastBuild (tm) Utility (c) 2008 Advanced Micro Devices, Inc.
LD No
LD 1
LD 1
LD 2
LD 3
LD 4
LD 5
LD 6
LD 7
LD 8
LD 9
LD10
[↑] Up
3. Exit FastBuild and restart computer to go to Windows.
4. In Windows, click "Cancel" to skip any "Found New Hardware Wizard".
Use driver CD and click on "AMD RAID Driver" to install the AMD RAID driver. The
RAID driver will be installed only when you select "RAID" in "OnChip SATA Type"
setting. If you do not select RAID, then RAID driver will not be installed.
[ Define LD Menu ]
[ Define LD Menu ]
RAID Mode Total Drv
RAID 0
RAID 1
−−−−
−−−−
−−−−
−−−−
−−−−
−−−−
−−−−
−−−−
−−−−
[ Keys Available ]
[↓] Down [ESC] Exit [Enter] Select
Capacity(GB)
2 163.99
2 249.99
−−−− −−−−−−−−
−−−− −−−−−−−−
−−−− −−−−−−−−
−−−− −−−−−−−−
−−−− −−−−−−−−
−−−− −−−−−−−−
−−−− −−−−−−−−
−−−− −−−−−−−−
−−−− −−−−−−−−
100
Status
Functional
Functional
−−−−
−−−−
−−−−
−−−−
−−−−
−−−−
−−−−
−−−−
−−−−