Wall Mount Installation - GE 29893 User Manual

W M
ALL OUNT
1. Carefully turn the phone over. Detach the mounting
bracket by pressing the tabs in. Turn the bracket
around so that it looks like the diagram. Align the
tabs on the bracket with the slots on the base and
gently press the bracket down until it snaps into
place. Turn the phone back over.
2. Plug one end of the short telephone line cord into the
LINE jack on the back of the base, and feed the cord
through the grooves on the bottom of the base so
that the phone rests flat against the wall. Plug the
other end into a modular telephone (wall) jack.
3. Connect one end of the power supply to the POWER
9V AC jack on the back of the base. Plug the other end
into an electrical (AC) outlet. The unit beeps once and
is ready for setup or to answer calls with the default
greeting and settings.
4. Remove the handset hook, turn it upside down, and
press it back into the slot until it clicks into place. This
prevents the handset from falling out of the cradle
while hanging on the wall.
5. Plug the coiled cord into the jack on the handset and
the jack on the side of the base.
6. Slip the mounting holes (on bottom of unit) over the
wall plate posts and slide the base down into place.
7. Place the handset in the cradle.
NOTE: The phone automatically defaults to touch-tone dialing. To change to pulse
(rotary) dialing, see "Setting the Dialing Mode." If you don't know which type of service
you have, check with the phone company.
CAUTION: Only use the ATLINKS USA 5-2434 power supply that came with this
unit. Using other power supplies may damage the unit.
I
NSTALLATION
Handset hook
O
N
ERASE VOL +
ON/OFF
MEM DIAL STORE
VOL -
FLASH
1 2 3
A
ABC DEF
QUICK DIAL
REDIAL/PAUSE
4 5 6
B GHI JKL MNO
HOLD
7 8 9
PQ WX
C TUV
RS
YZ
MEM DIAL
#
* 0
TONE OPER SPEAKER
mic
7