Section 2: In A Hurry - Honeywell XYR 5000 Series User Manual

Wireless base radio
Hide thumbs Also See for XYR 5000 Series:
Table of Contents

Advertisement

Honeywell Industrial Wireless

Section 2: In a Hurry?

!
Caution
If the Base Radio is not energized for more than
30 minutes, the Field Units should also be turned
off to preserve battery life. Leaving the Field
Units on when the Base Radio is not energized or
out of range will cause the Field Units to transmit
very frequently and drastically reduces their bat-
tery life.
If you are not receiving a "COMM OK"
message on the Base Radio check the
following:
Is the Base Radio set to the above
listed configurations?
Are all the Transmitters on?
Are the Transmitters set to the
matching configurations? (See Sec-
tion 5 of Transmitter and Base Ra-
dio User Manuals)
Are the Base Radio and Transmit-
ters unable to communicate due to
obstructions
or
distance?
Transmitter Manual: Transmitter
Placement section)
Did you perform the Simple RF
Placement Procedure? (See Trans-
mitter Guide: A Simple RF Place-
Rev. 3
11/04
This section summarizes what must be done in order to get the device in-
stalled, configured and in operation quickly. However, it does not provide
detailed or how-to information to perform the tasks outlined.
1.
Wire 24VDC power to the Base Radio (See Diagram below)
2.
Wire WIM RS-485 communications to the left-most terminal of Base
Radio (See side Diagram)
3.
Wire Modbus RS-485 communications to the center terminal of the
Base Radio (See Diagram below)
4.
Place terminating resistor in terminal only if Base Radio will be used
as an End Unit (See side Diagram)
!
5.
The Base Radio RF Settings should be configured as follows:
RF Channel to any available RF CHAN that matches the one
used by Transmitters you with which wish to communicate
(other than RF OFF)
Baud Rate to 76.8K or the Baud Rate used by Transmitters
with which you wish to communicate
Number of WI's = to the number of Transmitters to commu-
nicate with this Base Radio.
7.
Configure the Modbus settings
8.
Verify "COMM OK" message on Base Radio LCD screen
(See
User Manual
Wireless Base Radio
3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents