Kenmore 148.16656011 Use & Care Manual page 21

Cut tie wraps holding regulator and side burner valve in place underneath grill head control panel. Be
careful not to cut igniter wires. With the aid of an assistant, lift and place grill head onto cabinet. Grill
head sides go over attachment tabs on cabinet. Make sure that side burner valve and igniter wires
hang outside the cabinet, and that regulator hangs inside cabinet. Attach head to cabinet with 4
screws as shown.
Burner Box
Cabinet
Loosen the three screws attached to the left panel of the burner box 3 to 4 turns as shown. Hang the
side shelf by the slotted holes in its side onto the three loosened screws. Open the grill lid and use
the screw to fasten the side shelf from the inside of the burner box as shown. Tighten the three
previously loosened screws.
Loosen
Side Shelf
21
1/4-20 x 5/8"Screw
Qty. 4
1/4-20 x 1-1/4"Screw
Qty. 1