Door Alignment - Kenmore 795.5101 Series Use & Care Manual

DOOR ALIGNMENT

Before adjust the doors, remove the base grille.
See BASE GRILLE INSTALLATION for reference.
First select your adjusting tool, it could vary.
Type 1
Adjusting tool: flat blade screwdriver
If the freezer compartment door is lower than
the refrigerator compartment door, level them by inserting
a flat blade screwdriver into the groove of the left leveling
leg and rotating it clockwise.
Left leveling
leg
If the freezer compartment door is higher than the
refrigerator compartment door, level them by inserting a
flat blade screwdriver into the groove of the right leveling
leg and rotating it clockwise.
Height
difference
Height
difference
REFRIGERATOR INSTALLATION
Height
difference
Height
difference
Right leveling leg
Type 2
Adjusting tools: wrench
wrench ¾" (19 mm)
Height
difference
Height
difference
Using a ¾" (19 mm) wrench, t urn the keeper nut clockwise
to loosen the keeper nut.
Using a " (8 mm) wrench, turn the adjustment hinge pin
5
16
clockwise or ounterclockwise to level the c
freezer door.
After setting the level door, turn the keeper nut
counterclockwise to tighten.
Do not overtight the door adjustment screw. The hinge pin
can be pulled out. (Adjustable range of height is a maximum
of ½" (1.27 cm)).
AFTER LEVELING THE DOOR HEIGHT
Make sure the front leveling legs are completely
touching the floor.
11
5 " (8 mm) and
16
Keeper nut
Wrench
Up
Adjustment
hinge pin
Down
refrigerator and