Fujitsu Siemens Computers PRIMERGY Econel 200 Operating Manual page 20

Safety
Before operating the device
V
CAUTION!
During installation and before operating the device, observe the
instructions on environmental conditions for your device (see section
"Technical Data" on page 7).
If the device is brought in from a cold environment, condensation may
form both inside and on the outside of the machine.
Wait until the device has acclimatized to room temperature and is
absolutely dry before starting it up. Material damage may be caused
to the device if this requirement is not observed.
Transport the device only in the original packaging or in packaging
that protects it from knocks and jolts.
Installation and operation
V
CAUTION!
The server automatically sets itself to a voltage in the range of 100 V
to 240 V. Make sure that your local voltage is within this range.
This device has a specially approved power cable and must only be
connected to a grounded insulated socket.
Ensure that the power socket on the device or the grounded wall
outlet is freely accessible.
The ON/OFF button does not disconnect the device from the mains
voltage. To disconnect the line voltage completely, switch OFF the
mains power switch (if available) and remove the power plug from the
grounded insulated socket.
Always connect the device and the attached peripherals to the same
power circuit. Otherwise you run the risk of losing data if, for example,
the central processing unit is still running but the peripheral device
(e.g. storage subsystem) has failed during a power outage.
14
Important Notes
A26361-K970-Z102-2-7619