Releasing The Grill Element; Catalytic Liners (Where Fitted) - Westinghouse POR663 Owner's Manual

Removing the side racks (shelf supports)
• Grasp the shelf supports at the front.
• P ull them firmly inwards.
• T o install the shelf supports, see page 7.
Removing and replacing the oven light and side
light (where fitted)
• T urn oven light glass anticlockwise to remove it for globe
replacement�
• A special high temperature resistant globe should be
used� This can be purchased from the Customer Care
Centre�
• T o remove side light, place a spoon under the light glass
and lever off� Replace globe and snap glass cover back
into position�
warning
Make sure the appliance is turned off before
you remove or replace parts, to avoid the
possibility of electric shock�
CLEANING
26

releasing the grill element

We have designed the upper element with a hanger clip to
help you reach your oven roof for cleaning�
Retaining wire models
• L ift element up carefully.
• P ull hanger clip to the left or right to unhook it. The
element will drop down freely�
Rotating latch models
• Rotate latch 180º. The element will drop down freely.
catalytic liners
Some models come with Catalytic liners� These models
contain:
• 2 Catalytic side liners (to be fitted by you)
• 1 Catalytic fan cover (already fitted)
NoTe: If your oven does not have catalytic liners and you
wish to purchase them, they are available from the Customer
Care Centre.
operation
The catalytic liners are coated with a specially formulated
enamel coating, over a base of regular enamel� This enamel
coating has a rough surface which is also porous� During
normal cooking, fats and other food spatter is partially
absorbed into the surface and then oxidised away�
This oxidisation of the fat works best if the oven is set at high
temperatures. If you do a lot of lower temperature baking,
say around the normal 180ºC, then the cleaning process
may not be complete� Every now and then you should turn
the oven on to 260ºC for around one hour to completely
remove the soil�
cleaning
Should the panels become heavily soiled, they will need to
be taken out of the oven and cleaned by hand� They should
be soaked in warm, soapy water for at least 2 hours and
then wiped clean with a soft cloth�
NoTe: Solid cleaning powders, creamy cleansers, caustic
oven cleaners, steel wool or other scourers will ruin the
catalytic surface and must NeVeR Be USeD.
Removing the catalytic liners
• R emove Side Racks (see page 24).
• Lift the liner up to disengage the hooks.
• T he liners should now be free to be pulled in towards the
centre of the oven�
• Refer to page 7 for re-installing your side liners.
Removing and replacing the catalytic fan baffle
(where fitted)
• R emove the 2 retaining screws on the top edge of the
fan baffle.
• P ull the top edge towards you and then disengage to
bottom tabs from the oven back�
important
NoTe: The fan baffle must be replaced after cleaning.
• I nsert the two tabs at the bottom of the fan baffle into their
corresponding slots in the oven back�
• P ush the top home and insert screws firmly into
appropriate holes�
• The fan baffle must not be loose.
27
CATALYIC LINERS