Service Level Programming Functions; Sanitizing Instructions - Newco LCD-2 Dual Installation & Programming Manual

Section 3

Service Level Programming Functions:

Sanitizing Instructions

Press the + switch to enter sanitize mode. SAN will
appear in the display. (As shown in figure 15)
Fig. 15
Remove the product BIBs from the machine and
connect a BIB of sanitizing solution to the PUMP 1 BIB
connector. (The one on the left (as you face the
machine from the front.)
Place an empty decanter or other vessel under the dispense area of the machine.
Press the "Pump 1" (+) switch on the display panel to begin sanitizing.
When sanitizing cycle ends (2.5 minutes total: pump 45 sec., dwell 90 sec., & water 15 sec.), the
buzzer alarm will sound 3 times if enabled during the "Set-Up Programming". The machine will
automatically advance to "Pump 2". (Pump 2 will duplicate Pump 1's process.)
Disconnect the BIB of sanitizing solution from the Pump 1 BIB connector and connect it to the Pump
2 connector.
Press the "Pump 2 (–) switch on the display panel to begin sanitizing.
When sanitizing cycle ends, remove the sanitizing solution and replace the products. The machine
will automatically advance to the Prime Pumps mode.
To Prime: Press and hold the "Pump 1" (+) switch until a steady stream of product flows from the
dispense area into the vessel.
Press the "Enter" switch to advance to Pump 2.
Press and hold the Pump 2 (-) switch until a steady stream of product flows into the vessel.
Press and release the "Enter Switch until 3 dashed lines appear in the display.
Discard the contents of the decanter or vessel.
13-May-13 Phone: 1.800.325.7867 Fax: 1.636.925.0029 www.newcocoffee.com
12