Zanussi ZWF 16581 W User Manual page 28

Water inlet
This appliance must be connected to a cold
water supply.
1. Set the hose correctly by loosening the ring
nut. After positioning the inlet hose, be sure
to tighten the ring nut again to prevent
leaks.
Attention !
Do not place the inlet hose downwards.
Angle the hose to the left or right depending
on the position of your water tap as
indicated in the picture below.
2. Connect the hose to a tap with a 3/4"
thread. The inlet hose must not be
lengthened. If it is too short and you do not
wish to move the tap, you will have to
purchase a new, longer hose specially
designed for this type of use.
A minimum water pressure of 0.05 MPa (0.5
bar) is required for safe operation of the
appliance.If you cannot make the cold water
connection direct from the rising mains, you
may be able to operate the appliance from your
cold water storage system.
28
NOTE
Installation should
comply with local
water authority and
building regulations'
requirements.
There should be a minimum vertical distance
of 5.02m (16.5 ft) between the appliance's
inlet and the bottom of the water storage tank.
Water drainage
This appliance is designed to be permanently
plumbed into your home's drainage system
using one of the following methods.
1. Into a drainage standpipe.
Firstly form a hook in the end of the drain
hose using the «U» piece supplied. Place the
drain hose into your standpipe, which should
have an internal diameter of approximately
38mm thus ensuring there is an air break
between the drain hose and standpipe.
When discharging into a standpipe ensure that
the top of the standpipe is no more than 90
cm (35.4'') and no less than 60 cm (23.6'')
above floor level.