Zanussi ZWF 16581 W User Manual page 18

Operating sequence
You must select this option after you have set
the programme and before you press the
button .
8
The wash programme can be delayed from 30
mins - 60 mins - 90 mins, 2 hours and then by
1 hour up to a maximum of 20 hours by means
of this button.
Selecting the delayed start:
Select the programme and the required
●
options.
Select the delay start.
●
Press the button
8
●
hourly countdown.
The programme will start after the selected
delay has expired.
Cancelling the delayed start:
You can cancel the delay time at any moment,
before you press the button
already pressed it, and you wish to cancel the
delay time, proceed as follows:
• set the washing machine to PAUSE by
pressing the button
• press the buttons
10
displayed.
• press the button
8
programme.
IMPORTANT!
The door will be locked throughout the delay
time. If you need to open the door, you must
first set the washing machine to PAUSE by
pressing the button
8
has gone off. After you have closed the
9
door, press the button
Note!
The Delay Start cannot be selected with
Drain programme.
18
: the machine starts its
. If you have
8
;
8
until the symbol 0' is
again to start the
, wait until the pilot light
again.
8
Altering an option or a running programme
It is possible to change a few options before
the programme carries it out.
Before you make any change, you must pause
the washing machine by pressing the button
.
8
Changing a running programme is possible
only by resetting it. Turn the programme
selector dial to «Off» and then to the new
programme position. Start the new programme
by pressing the button
The washing water in the tub will not empty
out.
Interrupting a programme
Press the button
8
which is running, the corresponding light starts
to flash. Press this button again to restart the
programme.
Cancelling a programme
Turn the selector dial to «Off» to cancel a
programme which is running. Now you can
select a new programme.
Opening the door after the programme has
started
First set the machine to pause by pressing the
button .
8
If the light flashes and goes off, the door
9
can be opened. If it remains lit, this means that
the water level is too high.
In this case the door can not be opened.
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to «Off». After a few
minutes the door can be opened (pay attention
to the water level and temperature!).
. again.
8
to interrupt a programme