User Program Mode - NAPCO GEM-RP8LCD Installation Instructions Manual

PROGRAM MODE
PROGRAM MODE comprises two options:
!

User Program Mode

!
Zone Descriptions Mode
USER PROGRAM MODE is accessed through the Function Menu.
1. To enter the Function Menu, press
2. Skip through the functions by pressing
GRAM is displayed.
U
.
3. Press
4. When "USER PROG. MODE
for USER CODE programming.
To return to normal keypad operation, press
will automatically return to its normal operating mode if no activity
is detected for longer than one minute.
Note: A keypad shortcut of
ceed directly to USER PROGRAM MODE without the need to
scroll through the Function Menu.
USER PROGRAM MODE
Up to 8 personal User Codes may be programmed at the keypad.
Default User Code.
The first code programmed should replace the default (User 01) code.
Each user should be assigned his own dissimilar code and should be
cautioned against divulging his code to anyone else. Thus should it
become necessary to remove a user from the system, that one code
may be cancelled without affecting other codes, and that user would
then be prevented from entry.
Programming / Reprogramming a User Code
1. Enter the digit of the user number to be programmed.
2. Enter the new User Code (up to 4 digits). The new User Code is
automatically saved.
Repeat steps for each User Code to be programmed. While in User
Program Mode, the Armed, Status and SYS TBL display will continue
to flash. Follow the example below to program User 2's code to
1923.
User Program Mode Example:
1. Press 2 (Keypad beeps twice).
2. Enter 1 9 2 3
times confirming a valid entry. They keypad will automatically
save the new User Code for the user number, and reset to allow
a new user number to be programmed (or reprogrammed).
Note: A two or three digit User Code can be used by entering zeros
in the last digits. For example, "37" can be used by entering
"3700". For another example, "373" can be used by entering
"3730". This feature applies only to the GEM-RP8LCD, not the
GEM-RP8 keypad.
Changing or Canceling a Code
To change any User Code, merely program over the existing code.
To cancel a Code, press the number of the user to be deleted and
press Q. The User Code associated with the user will now be
deleted.
Exiting User Program Mode
To exit User Program Mode press
Notes:
While in User Program Mode, the ARMED and STATUS lights will
continue to flash and burglar and fire alarm functions are disabled.
In selecting your codes, do not program repetitive numbers (1111),
consecutive numbers (1234), your birth date, address, or other
R .
R until ACTIVATE PRO-
USERS=1" displays, the system is ready
C . The keypad
can be used to pro-
R 8
. The keypad will beep four
.
C
obvious combinations. If the keypad detects no Program Mode
activity for more than 4 minutes, a tone will sound. Press
to silence.
You can access ZONE DESCRIPTIONS MODE from User Pro-
gram Mode by pressing R
Ambush Code
The Ambush Code is a special four-digit code entered by the user to
disarm, typically to cause a silent report to be sent to the central station.
Thus, should the user be forced to disarm by an assailant, he can
silently signal an emergency while appearing to be merely disarming the
panel.
In dealer mode, program Ambush [20-4]. If enabled, the 8th User Code
will send an Ambush report when entered to disarm the system.
Additional Programming required:
Program User 8 Arm/Disarm Code.
Select reporting to Telco 1 [36-2] or Telco 3 [56-2].
C
.
Page 5