Table of Contents
Advertisement
Step 4. Firebox may be anchored to floor. Bend
down four (4) anchor tabs located at the base of
the firebox and secure to the floor by nailing
with 8d nails ( Figure 13 ).
Anchor Tab
Figure 13
Step 5. Firebox should be secured to side
framing members using nailing flanges. Use 8d
nails ( Figure 14 ).
Nailling Flange
Framing Stud
Figure 14
Note: The nailing flange and the area directly
behind the nailing flange is exempt from the
clearances described on the firebox clearance
label.
WARNING: DO NOT PACK OR FILL RE-
QUIRED AIR SPACES WITH INSULATION
OR OTHER MATERIAL. NO MATERIAL IS
ALLOWED IN THESE AREAS ( FIGURES 15
AND 16 ).
Combustible
Wall
" Space
Figure 15
Combustible
Wall
" Space
8d Nail
Figure 16
Step 6. The canopy must be installed for safe
operation of the heater.
NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE.
Canopy Installation
The factory-supplied canopy must be installed
on the firebox for safe operation. Refer to
Figure 17 .
Maintain
" Air Space
at Back
and Sides
Figure 17
Step 1. Remove the screws from the top front
Maintain
" Air Space
frame assembly. There are three (3) screws on
at Back
the 40" models and four (4) screws on the 45"
and Sides
models. Also remove the two (2) top screws on
the side frames.
Step 2. Align the canopy with the holes in the
Optional
Hearth
top frame.
Extension
Step 3. Replace the screws previously removed.
Step 4. Tighten side screws. Make sure the
Platform
Floor
canopy is level and secure.
OPTIONAL EQUIPMENT
Adjustable Canopy
The optional canopies are designed for use on
masonry and other wood-burning fireplaces,
but may also be used on these built-in un-
vented fireboxes when a brass or larger canopy
is desired for aesthetic reasons. Models AC-
SPB and AC-BK are designed for use with
UVFCE unvented fireboxes. Refer to the instal-
lation instructions provided with the canopy
for installation details.
Firebox
Opening
Canopy
3 Screws for 40" Models
4 Screws for 45" Models
9
Hide quick links:
Advertisement
Table of Contents
