Lower Deck Discharge Chute Deflector; Adjusting The Seat - Cub Cadet RZT 46 Operator's Manual

Lower Deck Discharge Chute Deflector

WARNING!
Never operate the mower deck
without the chute deflector installed and in the
down position.
The discharge chute deflector must be installed before operating
the mower.
1. Remove the keys that are attached with a zip tie to the
chute bracket.
2. Remove the flange lock nuts from the deck. Do not remove
the push nuts or carriage bolts, leaving them in place will
aid in installing the chute. See Figure 3-6.
54" Deck
Shown
Flange Lock Nuts
Push Nuts
Figure 3-6
3. Install the discharge chute deflector using the carriage
bolts, push nuts and flange lock nuts as shown in Figure 3-7
and securely tighten the hardware.
54" Deck
Shown
Discharge
Chute
Deflector
Push Nuts
Figure 3-7

Adjusting the Seat

To adjust the position of the seat, pull up and hold the seat
adjustment lever. Slide the seat forward or rearward to the desired
position; then release the adjustment lever. Make sure seat is
locked into position before operating the tractor. See Figure 3-8.
Carriage Bolts
Flange Lock Nuts
Carriage Bolts
Figure 3-8
S 2 — A & S
ection SSembly et
-U 11
p