Removing/Installing And Adjusting The Cutter Deck; Storage; Transport - Cub Cadet 769-11758A Manual

EN
Removing/installing and adjusting the
cutter deck
WARNING !
Suspension/lifter is spring-supported and
can spring back upwards.
Risk of injury
Remove the cutter deck slowly and
carefully from the suspension / lifter.
Only have this work performed by a
service centre.

Storage

Attention !
Damage to appliance materials
Store the device in a clean, dry enclosed space.
Protect the device from rust when storing it for
lengthy periods of time.
Protect the device from frost.
Clean the device and the grass catcher.
Wipe all metal parts down with an oily cloth or
spray them with oil to protect them from rust.
Charge the battery.
Remove the battery in the event of long-term
storage (e.g. over winter).
Charge up the battery every 6–8 weeks in the
event of long-term storage and before reinstalling.
Drain the fuel and shut down the engine – see the
engine manual.
Check the tyre pressure.
24

Removing/installing and adjusting the cutter deck

Transport

Attention !
Risk of serious damage to the transmission.
Do not tow the device.
Note
The device is not approved for public thor-
oughfares in accordance with national road
legislation (StVO).
Short distances
mower.
Putt the cutter deck in the transport position prior
to driving (see section "Adjusting the height of the
).
Drive the machine only short distances to change
its location of use.
Long distances
WARNING !
Danger posed by unstable and unsecured
ramps
Risk of serious injury to people and sever
damage to property
If you are transporting the device on a
the ramp is stable and secure.
WARNING !
Danger posed by inadequate fastening
Turbulence during transport
If you are transporting the device in a
trailer or lorry, fasten it and secure it
adequately.
Attention !
Environmental hazard due to leaked fuel
Do not transport the device in a tilted state.
Transport the device on a transport vehicle over
long distances.
push the device in neutral into/onto the transport
vehicle. Press the gear unlocking lever slightly
to the right and then fully back
Activate the parking brake and secure the device
against slipping.
see section
769-11758A