JETWAY Kocab 18G User Manual page 16

VGA is the 15-pin D-Subminiature female connector for display monitor.
(8) Serial Port COM1, COM2 : COM1, COM2A (COM2A only for Kocab 18P)
COM1, COM2 are the 9-pin D-Subminiature mail connector. The On-board serial port can be
disabled through BIOS SETUP. Please refer to Chapter 3 "INTEGRATED PERIPHERALS SETUP"
section for more detail information.
(9) Floppy drive Connector (34-pin block): FDD
This connector supports the provided floppy drive ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to the floppy drives.
(10) Primary IDE Connector (40-pin block): IDE1
This connector supports the provided IDE hard disk ribbon cable. After connecting the single
plug end to motherboard, connect the two plugs at other end to your hard disk(s). If you install
two hard disks, you must configure the second drive to Slave mode by setting its jumpers
accordingly. Please refer to the documentation of your hard disk for the jumper settings.
(11) Secondary IDE Connector (40-pin block): IDE2
This connector connects to the next set of Master and Slave hard disks. Follow the same
procedure described for the primary IDE connector. You may also configure two hard disks to
be both Masters using one ribbon cable on the primary IDE connector and another ribbon cable
on the secondary IDE connector.
PS/2 Mouse PRINT
PS/2 Keyboard COM1
Floppy Drive Connector
IDE1 IDE2
Pin 1 Pin 1
USB1
USB
VGA/COM2A
(Option)
Pin 1
14
LAN
MIC
LINE-IN
LINE-OUT