Installing The Side Trim Strips; Preparing The Water Connection - Viking 100 Series Installation Manual

Enclosure Preparation
NOTICE
Make sure you use the correct trim strip since there is a left and a right side strip. The flexible
material should be facing forward (Figure B).
11
• Adjust the front foot level with the
adjusting wrench to balance and raise the
dishwasher to the enclosure height.
• Adjust the rear foot level with a
screwdriver to balance and raise the
dishwasher to the enclosure height.
NOTICE
• Make sure the dishwasher is plumb
and notice dishwasher can be placed
with a small clearance under the
counter top.
• Turning the screwdriver in the
direction of the black arrows will
bring the dishwasher back feet up.
• Turning the screwdriver in the
direction of the white arrows will take
the dishwasher rear feet down.
Installing the
Side Trim Strips
• Remove the
adhesive tape
(Figure A).
• Place the trim
strips on the front
edge of the side
walls (Figure B).
Installation Preparation
Preparing the Water Connection (A)
• Install an easily accessible shut-off valve
(not supplied) in the water supply line. All
solder connections must be made before
the water line is connected to the
dishwasher's water inlet valve. Water can
also be supplied to the dishwasher by
using a flexible braided hose line.
WARNING
Installation should be performed by a
qualified installer. Work by unqualified
persons could be dangerous and may
void the warranty.
If the dishwasher is installed in a
location that experiences freezing
temperatures (e.g. in a vacation home,
cabin, etc.), you must drain all the
water from the dishwasher's interior.
Water system ruptures that occur as a
result of freezing are not covered by
warranty.
Installing the 90° Elbow Fitting (B)
12
• Check with your plumbing supply sources
for the proper hose and 90° elbow and
necessary fittings for the water supply line.
This material is not supplied and must be
purchased separately.
CAUTION
Do not overtighten the 90° elbow.
Doing so may damage the water inlet
valve and cause a water leak.
If the water supply line is to be copper
tubing, make certain that the elbow has a
compression fitting. Apply Teflon tape or
other pipe sealant when required. Orient the
water supply connection downwards as
shown in the figure so the water line can be
easily pulled underneath or on the side of
the dishwasher.