Materials Which May Be Needed; Materials Supplied; Parts Supplied; Dishwasher Parts Bag 1 - Viking 100 Series Installation Manual

General Information

Materials Which May Be Needed

Hot Water Supply Line – Minimum 3/8" O.D. copper tubing or metal
braided dishwasher supply line.
90° elbow with 3/8" N.P.T. male threads on one leg, and sized to fit
your water supply line (copper tubing/compression fitting, or braided
hose) on the other leg.
UL listed conduit connector or strain relief.
Teflon tape or other pipe thread compound to seal plumbing
connections.
Shut-off valve and fittings appropriate for hot water supply line (copper
tubing/compression fitting, or braided hose).
Silicone.
Glue.
7
General Information

Parts Supplied

Parts for your dishwasher will come in
several plastic bags. Check your parts bags
to make sure you have all the parts as listed
below.

Materials Supplied

Dishwasher Parts Bag 1

This dishwasher bag comes with
the following parts:
a. Side Trim Strips – Left
b. Side Trim Strips – Right
c. Adjusting Wrench
d. Screws Ø 1/8"x5/8"
(Ø 3.5mmx14mm)
e. Mounting Bracket – Left
f. Mounting Bracket – Right
g. Spring Clamp
h. Screw Clamp
j. Rubber Connector
k. Kickplate Bracket – Left
l. Kickplate Bracket – Right
m. Edge Protector
n. Clips
o. Kickplate
(kickplate without slots)
p. Kickplate
r. Screws Ø 1/8"x3/8"
(Ø 3.9mmx9mm)
s. Plastic Caps
t. Screws Ø 3/16"x1/4"
(Ø 4mmx6mm)
z. Steam Protection Foil
8

Dishwasher Parts Bag 2

v. Screws Ø 1/8"x5/8"
(Ø 3.5mmx14mm)
y. Screws Ø 3/16"x1-3/4"
(Ø 4mmx43mm)
Parts Attached to the Rear
of the Dishwasher
a. Side Trim Strips – Left
b. Side Trim Strips – Right
o. Kickplate
(Kickplate without slots)
p. Kickplate