Ultra Start 42 SERIES Install Manual page 20

Remote starter/alarms
Hide thumbs Also See for 42 SERIES:
Table of Contents

Advertisement

INSTALLATION MANUAL
Page 20
Menu 4- Tach Settings
Ignition ON-OFF-ON-OFF-ON
Press & Release Program Button
Press Button #4
Setting 1- Auto Tach Learn
1) Perform a System Reset. See page 15.
2) Turn the ignition key on. (Park lights will turn on).
3) Start the vehicle, the LEDs on the antenna will come on when a proper tach signal is detected*.
4) After approximately 30-35 seconds the park lights will go out then will flash twice and the siren
will chirp twice to confirm that a tach signal has been learned.
*If the LEDs do not come on, a proper signal is not detected. Try a different tach source and follow
steps 1 thru 4.
Setting 2 Over-Crank Adjustment.**
1) Enter Program Mode (turn ignition ON-OFF-ON-OFF-ON), press and release the Program Button.
2) Press and release the # button on the remote.
3) Press and release the Program Button twice. (LEDs will flash 2 times consecutively)
4) Press and hold the Program Button. The park lights flash and the siren will chirp one time.
*Each time the park lights flash and the siren chirps the setting is reduced.
5) Release the Program Button. (Exit Program Mode and test remote starter)
Setting 3 Under-Crank Adjustment.**
1) Enter Program Mode (turn ignition ON-OFF-ON-OFF-ON), press and release the Program Button.
2) Press and release the # button on the remote.
3) Press and release the Program Button three times. (LEDs will flash 3 times consecutively)
4) Press and hold the Program Button. The park lights will flash and the siren will chirp one time.
*each time the park lights flash and the siren chirps the setting is increased.
5) Release the Program Button. (Exit Program Mode and test remote starter)
**Repeat steps 1-5 if necessary.
Ignition 3x
Press and
On/Off
Release the
On/Off On
Program
Button
2WAY REMOTE STARTER/ ALARM
1 2 3
4
Press and
Release the
Press button
Program Switch
4 to enter
1x =Setting 1
Program
2x =Setting 2
Menu 4
3x =Setting 3....
Press and
Hold the
Program Switch
1x = Option 1
2x = Option 2
3x = Option 3....

Advertisement

Table of Contents
loading

This manual is also suitable for:

43 series

Table of Contents