Table of Contents
Advertisement
INTRODUCTION
WARNING: THIS APPLIANCE MUST BE EARTHED
RATING PLATE
This is situated on the front frame of the appliance
and can be seen upon opening the top cavity door.
Alternatively the rating plate may also be found on
the back or top of some models (where applicable).
The appliance must be protected by a suitably
rated fuse or circuit breaker.
appliance is given on the rating plate.
Do not remove the rating plate from the
appliance as this may invalidate the guarantee.
INSTALLATION
If your appliance has been damaged in transit,
contact your supplier immediately.
attempt to install it.
Your appliance left the factory fully packaged to
protect it from damage. If it is delivered without
packaging
and
damage
manufacturer cannot accept responsibility. Contact
you supplier for advice.
Once the packaging has been removed the
appliance should only be moved by hand.
NOT use a sack barrow or any other aid to lift the
appliance as damage may occur.
Connection to the electricity supply must be carried
out by a qualified electrician/competent person.
The electrical connection should be made using a
double pole isolating switch (cooker socket) with at
least 3mm contact separation in all poles.
cable must have conductors of sufficiently high
cross-sectional area to prevent overheating and
deterioration.
Six
square
millimetres
recommended cross-section area.
The rating of the
DO NOT
has
occurred,
the
DO
The
2
(6.00mm
)
is
the
The cable must be routed away from potentially hot
areas marked by X in the diagram below.
To move the appliance, open the oven door, and
lift the appliance by holding inside the top of the
compartment.
This is a type Y appliance which means it is free-
standing and can be fitted with cabinets on one or
both sides. It may also be fitted in a corner setting.
Ensure that the appliance is standing level.
Side walls which are above hob level should be
protected
by
material and MUST NOT be nearer than 40mm to
the hob side.
A nominal air gap of 2mm all around the appliance
is required to enable the appliance to be moved
into position.
Always ensure an air gap is maintained at hotplate
level. Tiles or other forms of deep wall covering
should not obscure this gap.
8
REAR VIEW
heat
resistant
non-combustible
Air gap
Advertisement
Table of Contents
