Total Access 916E And Total Access 924E Rear Panel Interfaces; Figure 3. Total Access 916E/924E Rear Panel Layout - ADTRAN Total Access 908e Hardware Installation Manual

Total Access 900e Series Hardware Installation Guide

Total Access 916e and Total Access 924e Rear Panel Interfaces

Figure 3 shows the Total Access 916e and Total Access 924e products' rear panel, which contains identical
interfaces regardless of the model.
VOICE
VOICE Connection
A single 50-pin female amphenol connector, labeled
analog FXS/FXO circuits. See
labeled VOICE , is located on the front panel.
The number of circuits used (1 through 24) is dependent on the Total Access 900e
Series model. FXO interfaces use circuits 17 through 24 depending on the model.
FXO 0/0 Interface
The interface is an RJ-11 connector and provides a single analog trunk for local call routing.
FXO 0/0
See Table A-2 on page 32
Network Interfaces
The network interfaces (
A-3 on page 32 for the network interface pinouts. The status LEDs, labeled
on the front panel.
10/100Base-T Ethernet Interfaces and LEDs
The Ethernet ports (
ETH 2 , are located on the front panel.See
10/100/1000Base-T Ethernet Interface
The Gigabit Ethernet port (
on the front panel. See
USB Interface (Future Release)
The USB interface is Type A USB host connector and is provided for use with 3G/4G modems or flash
drives. The status LED, labeled
limit the current drawn by a device connected to the USB port.
CRAFT Interface
The interface is an EIA-232 serial port (DCE) that provides for local management and
CRAFT
configuration (using a DB-9 female connector).
Connection directly to an external modem requires a cross-over cable.
64243916F1-34A
T1 0/1 T1 0/3
FXO
0/0
T1 0/2 T1 0/4

Figure 3. Total Access 916e/924e Rear Panel Layout

Table A-1 on page 33
for the FXO port pinouts.
T1 0/1 through T1 0/4
ETH 0/1 and ETH 0/2 ) are RJ-48 connectors. The status LEDs, labeled
Table A-4 on page 32
GIG 0/1 ) is an RJ-48C connector. That status LED, labeled
Table A-5 on page 33
USB , is located on the front panel. A USB power switch is used to
Copyright © 2010 ADTRAN, Inc.
ETH 0/1
USB
GIG 0/1
10/100/1000
ETH 0/2
BASE-T
VOICE , provides the interconnect wiring for the
for voice connector pinouts. The status LED,
) interfaces are DS1 RJ-48C pin connections. See
for the Ethernet port pinouts.
for the Gigabit Ethernet port pinouts.
Table A-6 on page 33
Physical Description
AC INPUT
CRAFT
BBU
through , are located
T1 1 4
ETH 1
GIG 1 is located
shows the CRAFT port pinouts.
Table
and
17