Advertisement
I
SCAMP
IGNITION CIRCUIT SWITCH
TESTING AND REPLACEMENT
Trouble
shooting
the
circuit
switch.
STEP #7
'-Using a drift punch and hammer, drive the switch
STEP #1
body out of the bracket. (See
Fig.
13).
This will break
Disconnect both leads from the
C.D. pack. the flange on the switch.
STEP #2
Connect a continuity meter or light to these leads.
STEP
#3
Push the plunger in. The meter should read
"0"
or
the light should go out.
STEP #4
Release the plunger. The meter should indicate a
completed circuit or the light will go on.
If the switch is defective, it requires replacement.
STEP #8
Assemble the new switch and lead assembly into
the bracket.
STEP #9
Install the switch retainer screw. Reconnect the
two leads onto the C.D. pack.
STEP #10
Adjust the switch plunger travel with the gauge,
part number 61 1702. Follow steps
1
thru 6 on page
14.
SAFETY WARNING: Proper adjust-
ment of this switch is necessary to in-
sure that blade motion stops within
the
required time.
Figure 13
STEP #5
To replace the
switch, it will
be necessary to
remove the flywheel for access to the switch. This
permits the brake arm to swing out of the way.
STEP #6
Remove the switch retainer screw. (See Fig. 6).
SERVICE BULLETIN REFERENCES
19-55
1983
Advertisement
