Operation - Grundig Music 51 DAB+ User Manual

OPERATION

General functions
Switching on and off
1
Press »ON/OFF« to switch the device on and
off.
Adjusting the volume
1 Adjust the volume using »
Adjusting the tone
1
Adjust the tone using »TONE«.
DAB mode
For the best DAB reception, it is sufficient to extend
the telescopic antenna and direct it accordingly.
Selecting the input source DAB
1
Open the menu with »MENU«.
Confirm the option »TO DAB« by pressing
2
»SELECT/i«.
– Display: »DAB«, then the name of a DAB radio
station.
Selecting stored stations
1
Select the station you want using the preset
buttons »1, 2, 3, 4, 5« (presets 1 to 5) or using
5« and the preset buttons »1, 2, 3, 4, 5«
»+
(presets 6 to 10);
or
select the desired station by pressing
»– TUNING +«.
Displaying DAB station information
1
To display information on the current DAB
station, press »SELECT/i« repeatedly.
– The following display appears in succession:
Information from the provider (e.g. to the
actual broadcast, the title of the song, the
e-mail address), the signal strength, the genre,
the current frequency, reference to signal
interference (at optimum signal display »ERR:
0«) the bit rate, the broadcasting format, the
current time and date.
Setting Dynamic Range Control (DRC)
for DAB stations
When you activate Dynamic Range Control, you
can hear lower sounds better in a loud environment.
22 ENGLISH
------------------------------------------------------------------------------------------------------------------------------
+ VOLUME
–«.
1
Open the menu with »MENU«.
2 Select the option »DRC« by pressing
»– TUNING +« and confirm by pressing
»SELECT/i«.
– Display: »DRC OFF«.
3
Select the option "DRC LOW" or "DRC HIGH"
»– TUNING
by presing
pressing »SELECT/i«.
4
Press »MENU« to end the display.
Note:
The DAB station must support DRC.
7
FM mode
For the best FM reception, it is sufficient to extend
the telescopic antenna and direct it accordingly.
Selecting the input source FM
1
Open the menu with »MENU«.
Select the option »TO FM« by pressing
2
»– TUNING +« and confirm by pressing
»SELECT/i«.
– Display: »FM«, then the frequency of a FM
radio station.
Selecting stored stations
1 Select the station you want using the preset
buttons »1, 2, 3, 4, 5« (presets 1 to 5) or using
»+ 5« and the preset buttons »1, 2, 3, 4, 5«
(presets 6 to 10).
Displaying RDS station informations
RDS (Radio Data System) is an information
system which is transmitted additionally by most
FM stations.
Notes:
It may take some time before all RDS
7
information is available.
GRUNDIG has no influence on the
7
correctness of such information.
1
Press »SELECT/i« repeatedly.
– The following display appears in succesion:
radio text (if offered), station type (PTY),
name of the radio station, the current time
and date.
+« and confirm by