Epson EasyMP Network Projection Operation Manual page 33

Using Multi-Screen Display
In a Windows environment, you cannot view the image being sent to
a virtual display on the computer. To adjust the image on the virtual
display, you must do so while viewing the projected image.
To perform mouse-based operations on the virtual display, move the
mouse pointer in the direction of the virtual display so that the
pointer appears on the virtual display.
c
To end projection for multi-screen display, click Disconnect on the
toolbar.
a
In a Windows environment, if the virtual display driver has
been enabled so that the mouse pointer can be moved outside
the limits of the screen, there may be occasions when you lose
track of the location of the pointer. If you are not using a
virtual display, clear the virtual display checkbox on the Add-
Remove Virtual Display screen so that the mouse pointer moves
back inside the screen's display area. To subsequently use multi-
display again, place a check mark against the required display
under Add-Remove Virtual Display.
To clear a check mark, see the following.
s "Enable the virtual display driver (Windows only)"
33
p.27