GE 200D9366P020 Owner's Manual And Installation Instructions page 21

CONNECTING THE REFRIGERATOR TO
1
THE HOUSE WATER LINE (cont.)
If you are using copper tubing, place a
A
compression nut and ferrule (sleeve) onto the
end of the tubing coming from the house cold
water supply.
If you are using the GE SmartConnect
tubing, the nuts are already assembled to the
tubing.
If you are using copper tubing, insert
B
the end of the tubing into the refrigerator
connection, at the back of the refrigerator, as
far as possible. While holding the tubing,
tighten the fitting.
If you are using GE SmartConnect
insert the molded end of the tubing into the
refrigerator connection,
at the back of the refrigerator, and tighten the
compression nut until it is hand tight. Then
tighten one additional turn with a wrench.
Overtightening may cause leaks.
Fasten the tubing into the clamp provided to
C
hold it in position. You may need to pry open
the clamp.
One of the illustrations below will look like the
connection on your refrigerator.
Icemaker-Ready Models
Icemaker-Installed Models
Installation Instructions
™
tubing,
™
21
TURN ON THE WATER SUPPLY
2
(icemaker and dispenser models)
Turn the water on at the shut-off valve (house water
supply) and check for any leaks.
PLUG IN THE REFRIGERATOR
3
On models with an icemaker, before plugging in the
refrigerator, make sure the icemaker power switch is set
to the O (off) position.
See the grounding information attached to the power
cord.
PUT THE REFRIGERATOR IN PLACE
4
Move the refrigerator to its final location. Make sure the
back side of the refrigerator engages the anti-tip
bracket properly. The anti-tip floor bracket should line
up with the cutout in the back bottom of the
refrigerator, and fit through the cutout when the
refrigerator is pushed into position. (Refer to page 18,
Step 2A for more information.)
LEVEL THE REFRIGERATOR
5
Turn the front roller adjusting
screws clockwise to raise the
refrigerator, counterclockwise
to lower it. Use a 3/8 hex
wrench with extension, or an
adjustable wrench.
To adjust the rollers on 21
These models also have rear adjustable rollers so you
can align the refrigerator with your kitchen cabinets.
Use a 3/8 hex wrench with extension to turn the
screws for the rear rollers—clockwise to raise the
refrigerator, counterclockwise to lower it.
models:
' Counter Depth