Cleaning And Maintenance - Zanussi ZDE67560W User Manual

Drying cycle complete / removing laundry
Once the drying cycle is complete, the lights
END and light 6 - FILTER are on. If the buzzer is
active, an acoustic signal sounds intermittently
for about one minute.
The drying cycles are automatically fol-
lowed by an anti-crease phase which lasts
around 30 minutes. The drum rotates at inter-
vals during this phase. This keeps the laundry
loose and free of creases. The laundry can be
removed at any time during the anti-crease
phase. (The laundry should be taken out to-
wards the end of the anti-crease phase at the
latest to prevent creases from forming.)

Cleaning and maintenance

Warning! The tumble dryer is not to be
used if industrial chemicals have been
used for cleaning!
Warning! You must DISCONNECT the
appliance from the electricity supply,
before you can carry out any cleaning or
maintenance work.
Cleaning fluff filter
The filter collect all the fluff which accumulates
during drying. To ensure that the dryer works
perfectly, the fluff filter must be cleaned after ev-
ery drying cycle.
The warning light FILTER , is on to remind you
this operation.
Caution! Never operate the dryer without
fluff filter or with damaged or blocked fluff
filter.
1. Open loading
door and re-
move laundry.
2. Remove the
filter which is
built into the
lower part of
the loading
aperture.
1) Only dryers with buzzer button
www.zanussi.com
1. Open door.
2. Remove laundry.
3. Remove filter after clothes has been re-
moved. Clean the filter.
Warning! Before You place the filter ,
please check it there is nothing inside the
filter seat.
4. Turn the programme selector to OFF .
Important! Clean the filter after each drying cy-
cle.
5. Close the door.
3. Open the filter
pressing the
button, among
two slots on
fingers. Clean
the filter using
dump hand or
cloth. After a
period of time,
a patina due to detergent residue on laun-
dry forms on the filters. When this occurs,
clean the filter with warm water using a
brush.
Close the filter and do not forget to put it
back.
Warning! Before You place the filter,
please check it there is nothing inside the
filter seat.
4. The filter can be positioned only to one
side. If position is wrong, the filter over-
hangs.
If the filter will not snap into place, the
loading door cannot be closed.
Cleaning the door
Clean periodically the interior part of the door to
remove any fluff. Accurate cleaning ensures cor-
rect drying.
9