Weider Body Works Pro 2.0 Bench User Manual page 7

3. Note: The following steps require two persons.
Attach the Adjustment Leg (8) to the Rail (3) with an
M10 x 90mm Bolt (44) and an M10 Nylon Locknut
(32).
Attach the Support Leg (6) to the Rail (3) with an
M10 x 75mm Bolt (43) and an M10 Nylon Locknut
(32). Do not overtighten the Nylon Locknuts; the
Adjustment Leg (8) and the Support Leg must
pivot easily.
4. Have a second person hold the ends of the Cord
(30) above the Seat (1). See the inset drawing.
Slide the Seat Bracket (2) onto the Rail (3). Make
sure that the Wheels (21) are on top of the Rail
and that the Large Bushings (23) are below the
Rail.
CAUTION:
Seat (1) is oriented as shown in the draw-
ing.
5. Attach the Upper Bar (5) to the Rail (3) with two
M10 Washers (35) and two M10 x 25mm Screws
(36).
Make sure that the
3
32
44
4
30
3
5
7
3
6
43
8
Silkscreen
1
2
21
3
23
5
3
35
35
36
21
23