Storage Drawer; Warming Drawer - GE JGBP35 Owner's Manual And Installation Instructions

Wire cover holder.
The storage drawer may be
removed for cleaning under the
range.
Oven Light Replacement
CAUTION: Before replacing your oven light bulb,
disconnect the electrical power to the range at the
main fuse or circuit breaker panel. Be sure to let the
light cover and bulb cool completely.
The oven light bulb is covered with a
removable glass cover that is held in place
with a bail-shaped wire. Remove the oven
door, if desired, to reach cover easily.
To remove:
Hold a hand under the cover so it
doesn't fall when released. With fingers
of the same hand, firmly push back the
wire cover holder. Lift off the cover.
Do not remove any screws to remove the
cover.
Removable Warming Drawer
Before performing any adjustments,
cleaning or service, disconnect the range
electrical power supply at the household
distribution panel by removing the fuse or
switching off the circuit breaker. Make
sure the warming drawer heating element
is cool.
Most cleaning can be done with the drawer
in place. However, the drawer may be
removed if further cleaning is needed. Use
soap and warm water to thoroughly clean.
To remove the warming drawer:
Pull the drawer straight out until it
stops.
Press the left rail release up and press
the right rail release down, while
pulling the drawer forward and free.
Removable Storage Drawer
The storage drawer is a good place to store
cookware and bakeware. Do not store plastics and
flammable material in the drawer.
The storage drawer may be removed for
cleaning under the range. Clean the storage
drawer with a damp cloth or sponge. Never
use harsh abrasives or scouring pads.
(on some models)
Do not touch hot bulb with a wet cloth.
Replace bulb with a 40-watt household
appliance bulb.
To replace cover:
Place it into the groove of the light
receptacle. Pull the wire forward to the
center of the cover until it snaps into
place. When in place, the wire holds
the cover firmly. Be certain the wire is
in the depression in the center of the
cover.
Connect electrical power to the range.
(on some models)
To replace the warming drawer:
Place the left drawer rail around
the inner left rail guide and slide it in
slightly to hook it.
Place the right drawer rail around the
inner right rail guide and slide it in
slightly to hook it.
Slide the drawer all the way in.
(on some models)
To remove storage drawer:
Pull drawer straight out until it stops.
Tilt the front of the drawer up and free
of the range.
To replace storage drawer:
Set the stops on the back of the drawer
over the stops in the range.
Slide drawer evenly and straight back,
so that the rails in the range are
engaged.
29