Adjusting The Sensor - Epson Stylus Pro 7600 Reference Manual

Sensor light
ON
Flashing
Flashing
rapidly
OFF
Switches
Auto
Manual

Adjusting the sensor

The angle of the sensors has already been adjusted when the unit
is shipped. But, if the Sensor light on the control box is flashing,
you need to adjust the sensor so that the light detector is aligned
with the light emitter. When they are aligned, the Sensor light
comes on.
Caution:
c
❏ Avoid locating the sensor in direct sunlight; otherwise, the
❏ Prevent fans or air conditioners from blowing directly on the
To adjust the sensor position, follow the steps below.
Indicates that the light detector is aligned with the light
emitter. This means that the Auto Take-up Reel Unit is ready
to wind your print out.
Indicates that the light detector and light emitter are not
aligned properly. See "Adjusting the sensor" for details.
Indicates that the Auto Take-up Reel Unit has
encountered a problem and stopped operation.
Indicates that the Auto Take-up Reel Unit is off.
For automatic take-up of roll paper when roll paper feeds
into the sensor unit's detection area.
For manual control of the take-up of roll paper.
auto take-up reel unit may not operate properly.
roll paper. If the paper is blown out of the sensor area, it will
not be taken up properly.
222