Dismantling
Remove the bar and chain. See the operat-
ing instructions.
On 268K and 272K, remove the cutting
attachment. See the operating instructions.
On 272S, remove the grinder attachment.
See the operating instructions.
Remove the spark plug and insert the piston
stop.
Use a spanner and remove the clutch. On
saws 36 and 41 use the service tool no. 530
03 11-12.
Note! Left-hand thread.
Saws with three
coil springs.
Remove the springs using a
screwdriver.
Then remove the clutch
shoes.
CENTRIFUGAL CLUTCH
Saws with one
long spring.
Remove the spring by first
lifting a shoe using a suitable
spacer (A).
Then remove the clutch
shoes.
Remove the clutch drum and needle bearing.
Saws with three C-springs.
A
Prise out the spring heels
using a screwdriver. Remove
the springs from the other
side using circlip pliers. Then
remove the clutch shoes.
English –
67