Changing The Ferrule - Husqvarna 36 Workshop Manual

Cleaning and Inspection
!
WARNING!
Ensure that the spring does not
fly out and cause personal injury!

Changing the ferrule

Remove the parts of the old ferrule.
Fit the new ferrule in the starter housing.
Use a wrench, spacer (A) and ball (B).
Splay out the ferrule on the inside as
shown in the figure.
58
– English
STARTER
Clean all parts and check the following:
The starter cord.
The dogs in the starter pulley.
That the pawls on the flywheel are OK, and
spring back towards the centre and move freely.
B
A