Pioneer AVIC-X3 Operation Manual page 142

MAN-AVIC-X3-EN.book Page 140 Wednesday, June 6, 2007 10:15 AM
Message
• No map data available on this
scale. Scaling up.
• No map data available on this
scale. Scaling down.
Failure in the memory recovery proc-
ess.
Memory navigation is presently not
possible.
The map data could not be stored.
Previous setting will be kept.
This function is not available with the
current map disc.
Failed to save to memory. Please re-
enter setting.
140
When
When the scale that had been previ-
ously displayed cannot be displayed
for the following reasons:
• The disc was ejected and the sys-
tem was changed to the memory
navi mode.
• In the memory navi mode, the map
was scrolled to outside the memory
area. Or, the vehicle moved outside
of the memory area.
• The map was scrolled to areas not
stored on the DVD Map Disc. Or,
the vehicle moved to unrecorded
areas.
• The map was scrolled from unre-
corded areas to the memory area.
Or, the vehicle moved from unre-
corded areas to the memory area.
Failed to complete the recovery of the
memory area because the disc could
not be read for some reason, result-
ing in deletion of the memory.
Recovery was performed for the
memory area after failing to read the
disc data for some reason (The mem-
ory area that was previously set will
be recovered).
The current position is "areas not
stored on the DVD Map Disc" and an
attempt was made to zoom in to
make the scale 500 m or more.
The settings could not be saved for
some reason.
What to do
If the desired scale cannot be
selected, insert the DVD Map Disc
that contains that area and then
change the scale.
• Clean the disc.
• Clean the DVD drive.
• Consult the Pioneer Local dealer if
this message persists.
• Clean the disc.
• Clean the DVD drive.
• Consult the Pioneer Local dealer if
this message persists.
Zoom in again after the vehicle
moves into an area stored on the
DVD Map Disc.
Or, replace the DVD Map Disc and
try to zoom in again.
• Retry.
• Consult the Pioneer Local dealer if
this message persists.