Switching The Auto Aerial Setting; Setting The Illumination Colour; Setting The Screen Colour; Changing The Wide Screen Mode - Pioneer AVIC-X3 Operation Manual

MAN-AVIC-X3-EN.book Page 116 Wednesday, June 6, 2007 10:15 AM
1
Touch "Camera" in the System menu.
2
Touch "Camera" to turn rear view camera
setting on.
Touching "Camera" switches between "On"
and "Off".
Unless this setting is "On", you cannot
switch to Rear View mode.
3
Touch "Polarity" to select an appropriate
setting for polarity.
Each time you touch "Polarity" switches
between the following polarity:
• Battery – When the polarity of the con-
nected lead is positive while the gearstick is
in the REVERSE (R) position
• GND – When the polarity of the connected
lead is negative while the gearstick is in the
REVERSE (R) position

Switching the auto aerial setting

If the blue lead of the navigation system is con-
nected to the auto aerial of the vehicle, select
either of the following settings.
• Radio – Extends the aerial only for the Radio
source. The aerial is stored when the source is
switched to another source.
• Power – Extends the aerial when the ignition
switch is turned on. The aerial is stored when
the ignition switch is turned off.
1
Touch "Antenna Control" in the System
menu.
Touching "Antenna Control" switches
between "Radio" and "Power".
Regardless of whether "Radio" or
"Power" is selected, turning off the igni-
tion switch will cause the aerial to auto-
matically retract.
116

Setting the illumination colour

The illumination colour can be selected Blue or
Red.
1
Touch "Illumi Color" in the System menu.
2
Touch desired colour.

Setting the screen colour

You can select one of five colours as the screen
colour.
1
Touch "Screen Color" in the System
menu.
2
Touch desired colour.
• White/Blue/Yellow/Red/Green

Changing the Wide Screen Mode

• For safety reasons, you cannot use some of
these navigation functions while your
vehicle is in motion. To enable these func-
tions, you must stop in a safe place and
apply the handbrake (see page 11 Inter-
lock for details).
1
Touch "Wide Mode" in the System menu
to select the desired setting.
Touch "Wide Mode" repeatedly to switch
between the following settings:
Full (full) – Just (just) – Cinema (cinema) –
Zoom (zoom) – Normal (normal)
Full (full)
A 4:3 picture is enlarged in the horizontal direc-
tion only, enabling you to enjoy a 4:3 TV picture
(normal picture) without any omissions.
Just (just)
The picture is enlarged slightly at the centre and
the amount of enlargement increases horizon-
tally toward the ends of the picture, enabling you
to enjoy a 4:3 picture without sensing any dispar-
ity even on a wide screen.